MiLAN MIL-RCM16A Dokumentacja Pobierz pdf (Strona 69)

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

Make sure Liftgate platform is open and resting on the ground before perform-

ing the following step.

WARNING

To prevent damage when installing valve cartridges & coils, torque valve

cartridge nut to 30 lbs.-in. max.

CAUTION

4. Reinstall “E” solenoid valve (FIG.

66-1) (if good) or a replacement.

Torque valve cartridge to 30 lbs.-

ft. and hex nut to 30 lbs.-in.

“E” VALVE

(3-WAY)

3. The “E” solenoid valve (FIGS. 69-1

and 69-2) may be stuck in the “open”

position. Remove the “E” solenoid valve

(FIG. 66-1). Next, check the valve cartridge

as follows. Push on the plunger in the

valve by inserting small screwdriver in the

open end (FIG. 66-2). If the plunger does

not move with a smooth, spring-loaded

action (approximately 1/8”) (FIG. 66-2),

replace the valve cartridge.

TYPICAL SOLENOID VALVES

(PUMP IS SHOWN FROM POWER DOWN

UNIT WITH HOSES)

FIG. 69-1

TYPICAL SOLENOID VALVES

(PUMP IS SHOWN FROM GRAVITY DOWN

UNIT WITH STEEL LINES)

FIG. 69-2

“E” VALVE

(3-WAY)

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 85 86

Brak uwag

MiLAN MIL-RCM16A Dokumentacja Strona 69