MiLAN MIL-RCM16A Dokumentacja Pobierz pdf (Strona 16)

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

1. Place empty 5 gallon bucket under drain plug.

GRAVITY DOWN LIFTGATES

2. Open and lower platform. Remove the drain plug

(FIG. 16-1). Drain hydraulic ﬂ uid from system.

Reinstall drain plug.

4. Reinstall ﬁ ller cap (FIG. 16-2).

POWER DOWN LIFTGATES

1. Place empty 5 gallon bucket under drain plug.

3. Disconnect the white wire (FIG. 16-2) from

motor solenoid. Lower the platform while draining

hydraulic ﬂ uid from system. Reinstall drain plug.

Reconnect the white wire to motor solenoid.

4. Remove ﬁ ller cap (FIG. 16-2). Reﬁ ll reservoir

until sight glass (FIG. 16-1) is half full.

6. Reinstall ﬁ ller cap (FIG. 16-2).

CHANGING HYDRAULIC FLUID

2. Open and raise platform to vehicle bed height.

Remove the drain plug (FIG. 16-1).

CAUTION

Keep dirt, water and other contaminants from entering the hydraulic system.

Before opening the hydraulic ﬂ uid reservoir ﬁ ller cap, drain plug and hydrau-

lic lines, clean up contaminants that can get in the openings. Also, protect the

openings from accidental contamination.

PERIODIC MAINTENANCE

3. Remove ﬁ ller cap (FIG. 16-2). Reﬁ ll reservoir

until sight glass (FIG. 16-1) is half full.

5. Raise platform to vehicle bed height. Check

hydraulic ﬂ uid again and, if needed, add more

hydraulic ﬂ uid until sight glass (FIG. 16-1) is half

full.

+50 to +120 Degrees F - Grade ISO 32

Below + 70 Degrees F - Grade ISO 15 or MIL-H-5606

NOTE: Use correct grade of hydraulic ﬂ uid for your location.

See TABLES 15-1 and 15-2 for recommended brands.

FILLER CAP

DRAIN PLUG

FIG. 16-1

FIG. 16-2

MOTOR

SOLENOID

WHITE

WIRE

SIGHT GLASS

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 85 86

Komentarze do niniejszej Instrukcji

Brak uwag

MiLAN MIL-RCM16A Dokumentacja Strona 16

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie MiLAN MIL-RCM16A