MiLAN MIL-RCM16A Dokumentacja Pobierz pdf (Strona 13)

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713

NOTE: Photocopy the PM CHECKLIST on the preceding page to help keep track of peri -

odic maintenance on the Liftgate. Keep completed form with maintenance records.

Change spin-on oil ﬁ lter. Visually check the entire Liftgate for excessively worn parts and

broken welds, especially the hinge pins. See Parts Manual for replacement parts.

Also, do the Semi-annual and Quarterly Maintenance checks.

Annually

Quarterly

Semi-annually

Visually check the platform hinge pins for excessive wear and broken welds. See Parts

Manual for replacement parts. Also, do the Quarterly Maintenance checks.

PERIODIC MAINTENANCE CHECKLIST

Never operate the Liftgate with parts loose or missing.

WARNING

Check the hydraulic ﬂ uid level in the pump reservoir. Refer to the CHECKING HYDRAULIC

FLUID procedure in the PERIODIC MAINTENANCE section.

• Grease zerk ﬁ ttings on two lower pivot points.

• Check for worn out links on each of the two platform chains.

• Check each end of the two platform chains to make sure they are fastened properly.

• Check that all roll pins are in place and protrude evenly from both sides of hinge pin col-

lar. Replace roll pins if necessary.

• Check that all WARNING and instruction decals are in place and legible.

• Check electrical wiring for chafﬁ ng and make sure wiring connections are tight and free

of corrosion. MAXON recommends using dielectric grease on all electrical connections.

• Check hoses and ﬁ ttings for chafﬁ ng and ﬂ uid leaks. Replace if necessary.

• Keep track of the grade of hydraulic ﬂ uid in the pump reservoir. Never mix two different

grades of ﬂ uid.

• If hydraulic ﬂ uid appears contaminated, refer to the CHANGING HYDRAULIC FLUID

procedure on following page.

• Check for rust and oily surfaces on Liftgate. If there is rust or oil on the Liftgate, clean it

off. Touch up the paint where bare metal is showing.

Damaged cylinder seals and contaminated hydraulic ﬂ uid can result from paint-

ing the polished portion of the cylinder rod. To prevent damage, protect the

exposed polished portion of the cylinder rod while painting.

CAUTION

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 85 86

Brak uwag

MiLAN MIL-RCM16A Dokumentacja Strona 13