MiLAN MIL-4750 Podręcznik Użytkownika Pobierz pdf (Strona 10)

Chapter 2

2-2 MIL-4750/MIL-4755 Master/Slave Modules

3. Slide the module into the slot through the guide rails.

4. Insert the module into the card-edge connector (port bay).

Make sure it is seated ﬁrmly.

5. Secure the module with the two thumbscrews located on

the faceplate of the unit.

6. Make all your network connections.

Note:

Do not plug a phone cable (RJ-11) into the RS-232 and/or RJ-45 connectors.

2.3 DIP Switch Settings

On the front panel of the MIL-4750 module is a two-position

DIP switch. Use Table 2-1 to conﬁgure this DIP switch.

Table 2-1: DIP Switch Settings

Note:

If D1 is “down” and a serial printer is attached, the printer will print a manufacturing test page. This

test page printed represents exactly what a user would see if a terminal was attached to the serial port.

Also, when D1 is “down,” the module is in serial conﬁguration mode. Network trafﬁc is not enabled.

D2 Mode/Description

Up Network mode. Telnet not allowed

Up Down Telnet and network mode (Default setting)

Down Up Diagnostic mode (only serial port active) or ascii test page

Down Down Diagnostic mode (only serial port active) or ascii test page

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 21 22

Brak uwag

MiLAN MIL-4750 Podręcznik Użytkownika Strona 10